10W UHF Radio Single Bandtwo Way Radio Repeater Outdoor
Min.Order : 1 Pieces Quick Quotation >
Conpany Profile
Product Details
1.Specification of repeater
General |
Frequency Range: | 400-490 MHZ ( Frequency spacing :10MHz) |
Frequency Spacing | 10MHZ |
Duplex Band Width | 1MHZ |
Modulation Type | FM 16F3 |
Operating Voltage | 12-14V |
Current | standby current : 0.3A Rx current : 0.8A Tx current :3.0A |
Frequency Stability | =2.5 PPM |
Channel Spacing | 25KHZ |
Weight | Approx 2kg |
2.Specification of Duplexer |
Frequency Range (MHZ) | RX:453.5---456.5MHZ TX:463.5---466.5MHZ |
Frequency spacing | 10MHZ |
Max Output Power (W) | 10W |
Receiving End Insertion loss (dB) | =2dB |
Transmitting End Insertion loss (dB) | <1.5dB |
Transmitting-Receiving End Isolation (dB) | =65dB |
Max VSWR | 1.5 |
Operating Temperature Range | -30-----+60°C |
Frequency Stability | Approx 2.5ppm/°C |
Matched Impedance | 50O |
Receiver | |
Simplex Sensitivity | =0.3uv(12dB SINAD) |
Duplex Sensitivity | <3dB |
Squelch Sensitivity | =0.2uv |
Selectivity | -70dB |
Spurious Radiation | -75dB |
Intermodulation Rejection | -75dB |
Residual Noise | -45dB |
DEMP FO | 6±3dB |
Audio Output Power | 4.0W |
Audio Distortion | <5% |
Working Mode | receiving mode |
Transmitter | |
Output Power | 5-10W |
Spurious Radiation | =80dB |
Residual Modulation | -45dB |
Audio Distortion | <5% |
Max Modulation | 5KHZ |
Pre-emphasis Frequencies | 6±3dB |
Working Mode | Transmitting Mode |
CPU Controller | |
Automatic Repeater Setting | |
MIC and PTT control | |
PC Programming | |
CTCSS and DCS |
Note:1.the repeater have MIC ,but it not standard accessories
2.the repeater just can do 10mhz ,you should choose 10mhz from 400-490mhz ,like 410-420mhz,422-432mhz,445-455mhz and so on.
3.the repeater software just can change channels frequency and CTCSS .but the factory should be in factory setting . if the repeater is finished ,you will can not change the frequency(like 410-420mhz,422-432mhz).
4.the repeater need antenna .the antenna need to put in the highest place ,the signal will be good.
5.the repeater need a cable to contact the antenna .the cable can not too long ,the cable will reduce the repeater power.
cable need -9 (is good ).
size
accessories
packing
Recommend Product