Find high quality cat face mill holder with competitive price here. Please rest assured to buy cat face mill holder with Shandong Jining Qingfeng Machinery Hardware Co.,Ltd

CAT-FMA Face Milling Holder

Brief introduction
Lathe Machine Tool Holder CAT Face Milling Cutter, used in the clamping of the cutter with the radial drive groove, such as the face milling cutter, the vertical disc cutter, the set type end mill, high speed and high precision machining .
   
Specifications
1. material:20CrMnTi
2. hardness:56-58
3. precision taper less than AT3
4. carbon depth less than0.8mm
5. pre-balance standard:G6.3 18000rpm,precision balance G2.520000rpm,25000rpm,30000rpm
6. Surface"environment protection",special coating surface treatment,improve the hardness and endurance of the surface,cleaness better,accuracy stable,surface.

The positive benefit:
* to shorten the processing time, increase production per unit of time.
* the overall product precision, appearance quality.
* the production cost can be reduced.
Customer trust, under the orders of the chip increase.
The cutter bar requirements are as follows:
To be clamped tighter, better rigidity, small deflection accuracy of machining tool, in this case, can the effectiveness of potential play!

The cutter bar check the accuracy of the matters needing attention:
1, the accuracy of the accuracy and reliability of the scale, the unit of measurement of at least 0.002mm.
2, the main test bar according to international standard
3, the accuracy of the tungsten steel mold qualified. Control shaft diameter tolerance within H6.
4, the cutter bar in the front, thoroughly clean all parts, such as the collet nut etc.. And at the same time, should pay attention to the cleanliness of the machine spindle.
5, the cutter bar clamping tungsten steel mold bar, the need to comply with all kinds of tool rod device description of. In order to avoid clamping precision caused by improper, distortion.
6, if the measurement. 180 degree deviation, the reason may be the bolt head or mechanical spindle taper precision etc..