Output    Current

1.4A~5.6A

Drive  Way

PWM constant    current chopping ,three phase Sine wave output current

Suitable  stepper motor

57,    60 series two phase stepper motor

Ambient  environment

-10?~55?   15~85%RH?No condensation. Non-corrosive, flammable, explosive,    conductive gas, liquid and dust

Keeping    enviroment

-40?~+55?, <93%RH,No condensation, no frost

Size (L*W*H)

                        118*75.5*34 mm

Net Weight

0.25 Kg

Output current setting

Users can set the driver Microstep by the SW1-SW3 three    switches. The setting of the specific Microstep subdivision, please refer to    the instructions of the driver panel figure

Automatic half current function

Users can set the driver half flow function by SW4.    "OFF" indicates the quiescent current is set to half of the dynamic    current, that is to say, 0.5 seconds after the cessation of the pulse,    current reduce to about half automatically. "ON" indicates the    quiescent current and the dynamic current are the same. User can set SW6 to    "OFF", in order to reduce motor and driver heating and improve    reliability.

signal Interface

PUL+ and PUL- are the positive and negative side of    control pulse signal; DIR+ and DIR- are the positive and negative side of    direction signal; ENA+ and ENA- are the positive and negative side of enable    signal .

Motor Interface

A+ and A- are connected to a phase winding of motor;    B+ and B- are connected to another phase winding of motor. If you need to    backward, one of the phase windings can be reversed .

Power Interface

It uses DC power supply,recommended working voltage is 20-50VDC,power is    over 100W .

Indicator Lightor

There are two indicator lights. Power indicator is    green. When the driver power on, the green light will always be lit. Fault    indicator is red, when there is over-voltage or over-current fault, the red    light will always be lit; after the driver fault is cleared, if re-power the    red light will be off .

Installation

The size of motor driver is 118×75.5×34mm,mounting    holes is 112mm?Chest and upright installation are ok,we suggest upright installation. During    installation, it should be close to the metal cabinet for heat dissipation.

1.4

0

0

0

2.1

1

0

0

2.7

0

1

0

3.2

1

1

0

3.8

0

0

1

4.3

1

0

1

4.9

0

1

1

5.6

1

1

1

200

0

0

0

0

400

1

0

0

0

500

0

1

0

0

800

1

1

0

0

1000

0

0

1

0

1250

1

0

1

0

1600

0

1

1

0

2000

1

1

1

0

2500

0

0

0

1

3200

1

0

0

1

4000

0

1

0

1

5000

1

1

0

1

6400

0

0

1

1

8000

1

0

1

1

10000

0

1

1

1

12800

1

1

1

1